Home » Blog » How We Made It: Monogram Pillow

How We Made It: Monogram Pillow

This monogram pillow shows the virtually endless possibilities for home decor with VersiFlex.

Tools and Supplies to Make it:

  • Sawgrass SG500 or SG1000 Printer
  • Sawgrass VersiFlex Inks 
  • VersiFlex Light Paper
  • Flat Heat Press
  • Chenille Pillow Cover

How to Make It:

  • For this project, we are using a chenille pillow cover we picked up at a local craft store
  • In the Sawgrass Print Utility, we chose Natural Fabrics for the product.
  • We printed this on 11″x17″ VersiFlex Light paper, but you can use smaller paper for a smaller design

How to Press It:

  • Turn on your press on and set the temperature to 375F (191C) degrees 
  • If you see any dust, lint roll your print area to make sure your surface is clean. 
  • Place your fabrfic on the press and line the paper up on top as you place it on the product.
  • Cover with blow out paper.
  • Press the fabric for 30 seconds at VERY HIGH pressure.
  • When finished, remove the fabric from the press and peel the paper off as quickly as possible. 

Tips & Tricks: 

  • With cotton fabric, pressure and temperature are very important. Use a heat gun to check the temperature of your press. For a smooth result, have the pressure on your press as high as possible.
  • You have flexibility with pillow covers to make the design as small or as large as you need to fit your printer and press.

Related Posts